2007 Catalina 309 Boat in Tracys Landing, MD 20779 US

2026

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• Annual AC / Heat system check up by Shiver Me Timbers 
• New cutlass bearing, new temperature sender, new PSS shaft dripless seal, and new fore spar ball valve and hoses for shaft seal. Installed by A.R. Marine Diesel Service
• Owner painted bilge area with Pettit EZ Bilge white paint. Also painted several areas under propeller shaft, and around hot water heater.

2025

• New Genoa Sail
• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• New steering cable, fittings, thimbles & clamps by East Coast Marine Rigging
• Annual AC / Heat system check up by Shiver Me Timbers 
• Owner tuned rigging
• New instrument panel on Edson Pedestal by A.R. Marine. Panel has new tachometer, fuel gauge, voltmeter, water temperature gauge, temperature alarm, and low oil pressure alarm. Warning lights for water temperature and oil pressure. New ignition switch.
• Fall engine check up by A.R. Marine Diesel Service
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter,
  cleaned engine sea water intake filter, & A/C water filter, changed engine pit pad, changed
  pump impeller, added shaft prop zinc, (zinc installed in spring 2026). All Yanmar parts

2024

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• New Furling Mainsail
• New galley sink faucet, new galley sink drain assembly, & pipes installed by Dependable Marine
• Annual AC / Heat system check up by Shiver Me Timbers 
• Fall engine check up by A.R. Marine Diesel Service: Installed new freshwater pump, new starter, starter solenoid, new thermostat, and changed engine coolant antifreeze.
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter,
  cleaned engine sea water intake filter, & A/C water filter, changed engine pit pad, changed
  pump impeller, added shaft prop zinc, (zinc installed in spring 2025). All Yanmar parts 

2023

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• New Ver 3 Axium+7 Raymarine GPS w/ Light House charts. New NMEA 0183 Converter kit with ACTi sense. New 1STNG NREA antenna. Installed by Marine Technical Services
• New sea water intake filter unit 
• Annual AC / Heat system check up by Shiver Me Timbers 
• New bronze filter unit for A/C, new Marelon seacock for A/C, all new hoses for AC system installed by Dependable Marine 
• Owner waterproofed Bimini, Dodger and connector piece
• Comprehensive rigging inspection w/ written report by East Coast Marine Rigging. Items requiring attention were fixed. Owner tuned rigging. New Selden furling drive unit for the mainsail, new New England 3/8-inch rope topping lift installed by East Coast Marine Rigging
• Fall engine check up by A.R. Marine Diesel Service. New stainless steel exhaust mixing elbow, new stainless steel Yanmar manifold and all new hoses for system installed 
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter, cleaned engine sea water intake filter, & A/C water filter, changed engine pit pad, changed pump impeller, added shaft prop zinc, (zinc installed in spring 2024). Installed new alternator and water pump belts. All Yanmar parts 

2022

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• New stainless steel ABA hose clamps on hot water heater hoses installed by A.R. Marine Diesel Service
• New clear head holding waste tank with 4-inch inspection and cleaning window. New hoses for head holding tank installed by Dependable Marine. Converted head to freshwater flush
• New continuous mainsail furling line installed by East Coast Marine Rigging
• Owner tuned rigging
• New Signal Mate 306-degree LED anchor light and new METZ AIS VHF antenna installed by East Coast Marine Rigging
• Fall engine check up by A.R. Marine Diesel Service
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter, cleaned engine sea water intake filter, changed engine pit pad, changed pump impeller, added shaft prop zinc, (zinc installed in spring 2023). All Yanmar parts

2021

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• Annual AC / Heat system check up by Shiver Me Timbers
• East Coast Marine Rigging inspected steering system
• New Marlon seacock for PSS dripless shaft seal, heat exchanger acid wash, new heat exchanger hot water hoses and clamps by A.R. Marine Diesel Services 
• New transmission oil dipstick. Purchased at Zimmerman
• New Raymarine i60 Wind system with short arm vane transducer installed by Marine Technical Services
• New plastic window on Bimini with new Velcro and new helm seat for cockpit by Canvas Connection
• Fall engine check up by A.R. Marine Diesel Service
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter,
  cleaned engine sea water intake filter, changed engine pit pad, changed pump impeller,
  added shaft prop zinc, (zinc installed in spring 2022). Installed new alternator belts. All Yanmar parts

2020

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• Annual AC / Heat system check up by Shiver Me Timbers 
• New primary fuel filter with clear plastic bowl for diesel inspection- RAC 215-30
• New sea water pump and belt installed by A.R. Marine Diesel Service
• New Raymarine wheel auto pilot installed by Marine Technical Services
• Fall engine check up by A.R. Marine Diesel Service: replaced two fresh water molded engine cooling hoses
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter,
  cleaned engine sea water intake filter, changed engine pit pad, changed pump impeller,
  added shaft prop zinc, (zinc installed in spring 2021). Installed water pump belt- 19 inches
  for better adjustment. All Yanmar parts

2019

• Owner sanded & painted bottom w/ Pettit ablative paint. Sanded & coated prop
• Annual AC / Heat system check up by Shiver Me Timbers 
• New engine mounts and did transmission alignment. Installed by A.R. Marine Diesel Service
• Fixed Windex wind indicator, tuned mast and permanent rigging, and installed a strain relief for electrical wires aloft by East Coast Marine Rigging
• (2) new G31 lead acid house batteries. Installed by Marine Technical Services
• Fall engine check up by A.R. Marine Diesel Service
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter, cleaned engine sea water intake filter, changed engine pit pad, changed pump impeller, added shaft prop zinc, (zinc installed in spring 2020). Grease Selden mast gears. Installed new alternator and water pump belts. All Yanmar parts

2018

• Herrington Harbour Marina shop services sanded & painted bottom – Use ablative Pettit Paint. Sanded & coated prop and added zinc. 
• New PSS dripless propeller shaft seal installed by A.R. Marine Diesel Services
• Forward hatch rebed by Phipps Boat Works
• Rigging inspection by East Coast Marine Rigging
• Fall engine check up by A.R. Marine Diesel Service
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter, cleaned engine sea water intake filter, changed engine pit pad, changed pump impeller, added shaft prop zinc, (zinc installed in spring 2020). Grease Selden mast gears. Installed new alternator and water pump belts. All Yanmar parts

2017

• Annapolis Yacht Service- Sanded bottom to bare gel coat and applied barrier epoxy coat, applied primer and two coats of Pettit bottom paint, sanded and painted prop, added zinc.  
• Annual AC / Heat system check up by Shiver Me Timbers 
• Flushed seawater side of cooling engine with Redlyme cleaner and added new Dexcool antifreeze by Zimmerman Marine.
• Steering system checked by Atlantic Spars & Rigging
• Alternator and water pump belts replaced by A.R. Marine Diesel Service
• Cleaned and greased Selden mast gears by East Coast Marine Rigging
• Annual engine check up by Zimmerman Marine 
• Fall engine service by Owner: changed engine & transmission oil, oil filter, two fuel filters, air filter, cleaned engine sea water intake filter, changed engine pit pad, changed pump impeller, added shaft prop zinc, (zinc installed in spring 2019). Greased Selden mast gears. All Yanmar parts  

• Large salon with 6'2" headroom
• Port dinette that can convert to double berth
• Starboard setee w/drop down snack table
• Composite Teak & Holly look cabin sole
• Overhead hatches w/ screens
• Ligjhts converted to LED
• Enclosed aft cabin w/ double bed and hanging locker
• Comfortable V-berth forward with sliding insert and storage below the berth. Has a folding door for privacy.
• Aire-Flow Hypervent Moisture Barrier – cut to fit V-Berth mattress. Custom sheet set for V-berth (2019)
• Spacious head with freshwater flush head and in head shower w/ sump pump.
• New head, holding tank and sanitation hoses means the boat does not smell! (2022)
• Cruisair 16K BTU Air Conditioning & Heat - Reverse Cycle
• Installed bronze filter unit for A/C, installed new Marelon seacock for A/C, and installed all new hoses for system (2023)

• 12V DC refrigerator
• Two burner propane stove w/ oven
• Custom cutting board to fit over stovetop for more flat surface prep area
• LPG tank for stove
• New galley sink faucet w/ hot & cold pressure water
• New sink drain assembly & pipes (2024)
• Microwave
• Keurig coffee maker

• New Raymarine Ver 3 Axiom+ 7’’  (2023)
• New Raymarine wheel auto-pilot w/ ST4000 MK2 Wheel drive (2020)
• New Raymarine wind sensor w/ short arm vane transducer,
• Raymarine ST60 TriData Speed & Depth
• Icom VHF w/Cockpit RAM Mike
• New METZ AIS VHF antenna (2021)
• Ritchie Pedestal Mount Compass
• New Signal Mate 306-degree anchor light (2021)

• All electrical wiring is color coded and tinned to prevent corrosion 
• D.C. Electrical System with selector switch and panel circuit protection
• A.C. Dockside Power with outlets and polarity indicator, circuit protection and galvanic isolator
• Battery charger
• 50' 30 amp shore power cord  
• ProMariner Galvanic Isolator
• West Marine Group 27 starting battery (2024)
• (2)  Interstate Marine SRM -31 house batteries (2019)
• New green light indicator for “DC Service On” on electrical panel (2022)  
• New sea water intake filter unit (2023) 
• Whale connects with 2 Quick connects & hose for bypassing winterizing with antifreeze the hot water heater- save six gallons of antifreeze every year.   
• 50’- ½” drinking water hose with 5-micron string sediment filter & housing to fill potable water tank from pier marina faucet.   

• White Fiberglass Deck with Grey Two Tone Non-skid
• Stainless Hand Rails on Cabin Top
• Double Lifelines w/ boarding gates on Port & Starboard
• (4) Opening Deck Hatches w/ screens
• Double Rail Bow and Stern Pulpits
• Maxwell electric windlass
• Bow roller
• Fortress FX-23 anchor w/ 10ft ¼ chain and 50ft  ½” line  (2018)
• 25lb West Marine Fluke Anchor as spare (2017)
• Walk Through Stern with Removable Helm Seat
• S/S swim ladder
• Teak Cockpit table
• Port & Starboard stern seats
• Hot & Cold cockpit shower
• Large Cockpit locker  
• Made seat for helm in cockpit. Made from U.V. resistant fabric with line attachments to stern railings. Build with zippers to allow for easy cleaning (2022)
• Bimini, Dodger & connector piece in great condition. 
• New pedestal cover (2018)
• Winch covers

• New Furling Main sail from Catlina Direct with C-309 emblem and #63 on sail (2023)
• New 135% Genoa sail from Catalina Direct with C-309 emblem and #63 on sail (2024)
• All sail controls are mounted on deck and led aft to the cockpit 
• New steering cable, fittings, thimbles & clamps (2024)
• New topping lift with New England 3/8-inch rope (2023)
• New continuous mainsail furling line (2022)
• Double Spreader Mast 
• Tie-rod structural system attaches rig to hull with leak-proof ball and socket chainplates
• Internal Halyards
• Traveler Control, with Adjuster System
• Midboom Sheeting with Traveler
• Rigid Boom Vang
• Inboard Genoa Tracks
• Spare Jib Halyard
• Lewmar 34ST primary winches
• Lewmar 28ST halyard & main sheet winches

• Yanmar 3YM20 FWC diesel  
• Single lever engine controls at pedestal
• 3 Blade Prop
• New new cutlass bearing (2026)
• New temperature sender (2026)
• New PSS shaft dripless seal (2026)
• New fore spar ball valve and hoses for shaft seal (2026)
• New engine panel at helm (2025). Includes new Tachometer w/ engine hour meter-calibrated for 3YM20 engine, new fuel gauge, new voltmeter, new water temperature gauge, new temperature alarm, and low oil pressure alarm. New warning lights for water temperature and oil pressure. New ignition switch with protective cover, new start and stop buttons.
• New freshwater pump (2024)
• New starter & starter solenoid (2024)
• New thermostat (2024)
• New stainless steel exhaust mixing elbow (2023)
• New stainless steel Yanmar manifold and all new hoses for system (2023)
• New Marlon seacock for PSS dripless shaft seal (2021)
• New Racor primary diesel fuel filter with clear bowl for inspection of water / fuel separation (2020)
• New sea water pump and belt (2020)
• New engine mounts (2019)
• New heat exchanger hot water hoses and clamps (2021)

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.