1991 Hylan Offshore Steel Cutter Boat in Lincolnville, ME 04849 US
Built in 1991
Offshore Steel Cutter
1 Engine (Yanmar)
34 feet
--
Steel
HULL CONSTRUCTION:
- 1" steel on keel.
- 3/16" at waterline with full keel and attached rudder.
- 10 gauge heavy hull, painted red with Interlux Brightside.
- Steel decks and trunk cabin.
- 2016 new bowsprit and boomkin; S/S bow rail with anchor roller.
- Steel rudder with oak tiller steering (also emergency tiller).
- Windvane self steerer with trim tab off rudder.
- Top of trunk cabin is plywood and epoxied with fiberglass over.
- Boom gallows.
- S/S stern mounted ladder.
- Furuno radar on stern mounted mast.
- Teak stand for binnacle compass.
- Mainsheet traveler mounted on bridgedeck.
- S/S stanchions and double lifelines.
- Painted white sheer stripe; black bottom.
- Manual Wichan wildcat manual windlass.
- 5' bowsprit; 4' boomkin.
TANKAGE:
Fuel: 2004 30 gallon S/S tank.
Water: 2-30 gallon bladder tanks under cabin sole.
Holding: 15 gallon bladder tank with y-valve.
ENGINE:
- 1994 Yanmar 3GM30F diesel, 24 hp, 3 cylinder, FWC.
- Racor fuel filter.
- S/S shaft and 3 blade prop.
- Automatic fire extinguisher.
ELECTRICAL:
- 12V electrical system with circuit breaker panel.
- Two deep cycle lead acid batteries in aft end of engine room.
- Pro-Charge Ultra 10 amp charger.
ACCOMMODATIONS:
- For 4 in a very attractive varnished mahogany interior.
- Offset double berth forward to starboard.
- To port is extra storage shelves, and a chart table, Nav area with GPS & SSB radio.
- Next aft is the main salon with settee and pilot berth to port and settee berth to starboard.
- A drop leaf dining table is on centerline with a Force 10 LPG heating stove on the main bulkhead. Many storage lockers outboard.
- The overhead has varnished oak beams; there is a 1" teak cabin sole.
- Bronze opening ports.
- Further aft to port is an enclosed head with S/S sink.
- Opposite to starboard is the galley with a two burner Force 10 LPG stove with oven, S/S sink with manual cold water pump.
- No refrigerator.
- Dishes & cutlery.
ELECTRONICS:
- Raymarine 2000 autopilot.
- Furuno Radar.
- Old Garmin 128 GPS & Depthsounder.
- ICOM SSB transmitter.
- Danforth White binnacle compass.
SAILS & RIGGING:
- Cutter rig.
- Metalmast aluminum mast and boom.
- Mainsail, loose-footed.
- Genoa; Yankee; Staysail and Storm Jib & Trysail.
- Asymmetrical spinnaker and twin running sails.
- No roller furler on genoa.
- S/S standing rigging, original.
- Dacron running rigging.
- 2 Barient sheet winches.
- Mainsheet traveler on bridgedeck.
- Boom vang; spinnaker pole and gear.
EQUIPMENT:
- 33 lb & 22 lb Rocna anchors.
- 50 lb Paul Luke storm anchor.
- 20 lb Danforth anchor.
- 60' chain and two 5/8" 300' rodes.
- Hand bearing compass.
- Electric and manual bilge pumps.
- Life ring; fire extinguishers; life jackets.
- Portable searchlight.
- Winter cover and frame.
- Jack stands.
- Fenders, docklines, fenderboard.
- Signal flags; bell; boat hook.
- Clock and barometer.
- Stereo.
COMMENTS: Looking to go offshore in a proven design and built of steel to heavy scantlings? WESTERN WAY is ready for her next adventure. Designed by Merrit Walters and her hull built by the renowned Doug Hylan in Brooklin, ME, the owner did all the interior and finish work to very high standards. She is a handsome cruiser with a Cutter rig for easy short-handed sailing. Due to their advancing years, her sellers must sell. They successfully sailed her to Ireland, Bay of Biscay and Spain, Mediterranean, Canary Islands, and across to Barbados and the Caribbean.
Please watch the Boat Fools Video and call us for your inspection. Thank you for your interest.
Potential purchasers should assume that items on the vessel at the time of viewing, but not specifically listed on this specification sheet, are not included with the sale of the yacht. These specifications are believed to be correct but cannot be guaranteed. Specifications are provided for information purposes. Data was obtained from sources believed reliable but is not guaranteed by owner or brokers. Buyer assumes responsibility to verify all speeds, consumptions, capacities and other measurements contained herein and otherwise provided, and agrees to instruct his surveyor to confirm such details prior to purchase. Vessel subject to sale, price and inventory changes, and withdrawal from market without notice.
Mechanical Disclaimer: Engine and generator hours are as of the date of the original listing and are a representation of what the listing broker is told by the owner and/or actual reading of the engine hour meter. The broker cannot guarantee the true hours. It is the responsibility of the purchaser and/or his agent to verify engine hours, warranties implied or otherwise, and major overhauls as well as ALL other representations noted on the listing.
DISCLAIMER TO BOARD VESSEL: In the event the Buyer boards the vessel either on land or in the water without a broker or owner, the Buyer(s) agrees and understands he boards at his sole risk and liability.
Price History
| Date | Event | Price |
|---|---|---|
| 6/21/26 | Initial price | $23,000 |
Videos from Gray & Gray Yachts on this 1991 Hylan Offshore Steel Cutter
Be the first to know when similar boats hit the market
Get notified when new boats become available
Boats For Sale in Maine, United States Similar to the 1991 Hylan Offshore Steel Cutter
Compare with similar boats and find the perfect one for you.
 1991 Hylan Offshore Steel Cutter | |||||
|---|---|---|---|---|---|
| $23,000 | $25,000 | $34,000 | $39,900 | $50,000 | $52,500 |
| Lincolnville | Eliot | Rockport | Rockland | Rockport | Rockland |
| 34' | 35' | 32' | 35' | 26' | 36' |
| 10' | - | - | - | - | - |
| 4' | - | - | - | - | - |
| Yanmar | Yanmar | Beta | Yanmar | QuieTorque | Volvo |
| 24 hp | 54 hp | - | 30 hp | 10 hp | - |
| 4 | 482 | 737 | 2376 | 341 | 823 |
Meet the Broker
Address
Boat Location
Contact Gray & Gray Yachts about 1991 Hylan Offshore Steel Cutter
36 York St, York, ME, 03909
Login with Google