2007 Beneteau 423

Entering the vessel from the forward section of the cockpit, down a set of stairs puts you into the

main cabin. Immediately to port is an enclosed marine toilet and shower. Aft is a cabin with a double

berth, in the port rear quarter. Beneath this berth is the location of the water tank and battery

switches.

To starboard is a second cabin with a double berth as well. Forward of this is

the chart table and a convertible dinette. On the port side is the galley, running along the port side

of the hull. Continuing forward through the bulkhead, immediately to starboard is a second enclosed

marine toilet, and the master cabin forward with ensuite composting head and shower. There is a chain locker located in the

forepeak. Throughout the vessel there are various hanging lockers, cabinets, drawers and other

storage areas. The auxiliary engine is located beneath the companionway ladder. The fuel tank is

located beneath the starboard double berth.

• 135 Genoa - Preciscon Sails 2023
• Harken furler
• In mast furling main sail
• 2 Lewmar #54 primary winches
• 2 Lewmar # 40 Winches
• Boom vang
• Traveller

I : 49.54 ft

J : 16.54 ft

P : 43.44 ft

E : 14.83 ft

Working Sail Area : 915.58 sq ft

• Lewmar H3 windlass
• Hot and cold cockpit shower.
• Waterproof cockpit speakers.
• Mooring: mooring lines and fenders.
• Bimini
• Extended mast (+70cm) with track and cars.
• In the cockpit: Raymarine ST60 Speedo/depth sounder, Raymarine ST60 windvane anemometer, and Raymarine ST6001+LS40 autopilot.
• On steering wheel console: multifunction GPS screen, plotter, Raymarine C80LCD colour chart reader compatible with Navionics Gold cartography (with charts)
• Raymarine radar
• Walk thru transom.
• Transom seats
• Cockpit cushions
• Teak slatted pivoting helm seat for easy access to scoop transom (B?n?teau patent).
• The cockpit is fitted with five lockers:
• 2 side lockers with teak slatted lids.
• 2 aft lockers with teak slatted lids.
• 1 separate gas locker.
• All cockpit bench seats are teak slatted.
• The leather-trimmed steering wheel is pivoting for easier movement around the cockpit.
• Engine control lever.
• Steering compass.
• Console for navigation instruments.
• Handrail.
• Cup holder.
• 12 Volt socket.
• Oddments locker with stainless steel protection on the front of the console.
• The cockpit table is teak with removable leaves. The table support is stainless steel with a footrest.
• The engine control panel is built in to the port coaming with a PMMA protective cover.
• Manual bilge pump.
• Overhead lamp.
• Cold water shower.
• 2 loudspeakers.
• Life Sling

• Raymarine E-80 display
• Raymarine integrated chart plotter
• Raymaine radar
• Raymarine ST6002 Autopilot
• Raymarine ST 60+ Wind display
• Raymarine ST60+ Tri Data display
• ICOM IC-M412 VHF
• Dual MXD44 media receiver
• Cockpit and salon speakers
• Insignia flat screen TV

• Victron 3,000 watt inverter/charger
• Victron 30 amp dc to dc converter bluetooth
• Victron 50 amp dc to dc converter bluetooth
• Bictron 100/50 MPPT solar controller, 500 watts of solar bluetooth
• Victron BMV-712 Blue tooth battery monitor
• 2 X 200 amp hour lithium batteries with internal BMS system
• Total - 400 amp hours lithium power
• 5 Solar panels
• DC panel
• AC panel
• Electrical panel:
  • 16-switch 12 V electrical panel plus 4 x 220 V breakers, back-lit by blue indicator lights.
  • Cigarette lighter socket.
  • Double protection to electrical panel, differential and bi-polar thermal circuit breakers for 220 V and 12 V thermal circuit breakers.

• Supply:

  • The 12V electrical circuit is supplied by

• Resource management indicators:

  • Voltmeter.
  • Ammeter.
  • Electric fuel tank gauge on engine control panel.
  • Electric water gauges.

• Lights:

  • Approved navigation lights.
  • Bow and stern navigation lights.
  • Steaming light (masthead light).
  • Anchor light.
  • Engine compartment with foam sound-proofing.
  • Engine control panel with rev. counter and alarms on port cockpit coaming.
  • Stainless steel propeller shaft with GRP protection moulded into the hull.
  • Fixed three- blade propeller.
  • Engine mounting built into the inner mould.
  • Rotomoulded 200 L diesel tank, fitted with electronic gauge.
  • Saltwater and diesel filters with separators.

• Force 10 3 burner stove with oven and broiler
• Isotherm refrigeration system
• Insignia microwave
• Double stainless steel sink
• Custom faucet
• Hot & cold pressure water
• Electric & engine water heater 2022
• Ample counter and storage space
• Stainless steel bottle rack..
• Lewmar opening ports (583 mm x 123 mm) with curtains.
• Opening hatch (272 mm x 417 mm).
• Two halogen deckhead lights.

2021-2022

Replaced engine heat exchanger and stainless steal exhaust elbow

Port head converted to Freshwater electric flush, new macerator & hoses

Fwd head, holding tank, hoses removed.  Installed airhead composting toilet system.

New sink water faucet, new fresh water filtration system

New water heater - electric / engine coolant heat

Victron 3k inverter charger, all outlets always live.  Separate 120v line in garage.

Victron 30 amp dc to dc converter bluetooth

Victron 50 amp dc to dc converter bluetooth

Victron 100/50 MPPT Solar controller, 500 watts of solar bluetooth

Victron BMV-712 Blue tooth battery monitor

All Victron equipment installed in STB cabin well above waterline with easy access

2 x 200 amp hour lithium batteries with internal BMS systems for a total of 400 amp hours of lithium

2023

New Dodger with Makrolon, connector, and bimini;  Pre-zippered for future full enclosure

Cabrillo Boat Shop haulout.   $13k

Remove and shim rudder to take out play

Remove fwd head intake & mascerator thru-hull valves fiberglass

New engine intake thru-hull valve

New port head macerator thru-hull valve

New port head sink & shower thru-hull

Remove port head sea water intake thru-hull fiberglass

Iron keel strip, fill, fair, treat, prime, and paint

Paint triple coat waterline, leading edges, and rudder.  Double coat hull

Z-Spar bottom pro gold modified expoxy hard paint non-ablative

New headsail furling 135% Precision Sails 8 0z Dacron Navigator Package

2024/2025

Updated chart plotter maps.

New Lewmar H3 Anchor windless with new separate battery installed in the bow

New Lewmar wireless & wired remote anchor windless controls

New 120’3/8 BBB chain with press in color coded markers with chart in anchor locker

280’ feet anchor rode.

85 lbs Matus Anchor

New Isotherm refrigerator freezer combo unit.

Convert refrigerator drain pump to high volume emergency water drain pump

Spares – Factory Engine Raw water pump, Factory Engine fresh water pump, Factory engine high amp alternator, Factory Engine starter, Factory Engine motor mounts 2x, Fresh drinking water pump, mascerator

• The hull is single-skinned GRP construction.
• Reinforced points (keel, rudder, chain plates, hull-deck joint) help to strengthen the structure.
• A structural inner moulding is bonded and laminated to the hull. Its structural role is important as it takes and absorbs the stresses at pressure points (shroud chainplate tie rods, keel, rudder, etc.), and spreads any loads guaranteeing reduced strain on the hull.
• The surface of the inner moulding makes cleaning easier and provides a better finish.
• The standard hull is white with blue and silver livery. Steel blue is available as an option.
• The deck is sandwich construction (glass fibre and balsa) for an optimal strength/weight ratio and excellent thermal and sound insulation.
• A  non-slip surface increases safety over all areas of movement on deck.

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.