2024 Beneteau First 27

DECK EQUIPMENT

• 45 cm / 18 inch high stainless steel pulpit, pushpit and six stanchions with double lifelines

• Stainless steel bow and stern mooring cleats

• Stainless steel chain plates for side shrouds and forestay

• Wichard folding pad eyes on the stern for backstay attachment

• 2x Harken STA15 secondary halyard winches and 2x Harken STA20 jib and gennaker trim primary winches

• 2x Spinlock winchfeeder on the coachroof

• Two rope bags and two winch handle bags, Outils Océans & First branded

• Wide Ronstan aluminium mainsail traveller installed over the tiller

• GRP tiller in white with Spinlock EA1200DS tiller extension

• Laminated tempered glass windows on both sides of the hull

• Laminated tempered glass windows on both sides of the cabin

• Cabin opening hatch of 58 cm x 58 cm / 23 inch x 23 inch for light, ventilation and deck access to the mid-section compartment

• Deck opening hatch of 25,5 cm x 25,5 cm / 10 inch x 10 inch for front cabin ventilation

• Bow anchor locker

• Cockpit benches with lockable storage compartments

• Stern storage compartment cover

• Manual bilge pump operated from the cockpit 

 Indoor/outdoor table attachment on the cockpit floor

MAST & RUNNING RIGGING

• Seldén aluminium mast and boom with two sets of swept-back spreaders

• Aluminium groove for plastic sliders system for mainsail

• Linked 1x19 standing rigging with bottle screw adjusters

• Backstay with purchase cleat on the stern

• Retractable aluminium bowsprit controlled from the cockpit

• Dyneema pole-out control line

• Dyneema gennaker tackline

• Mainsail halyard 

• Jib halyard

• Masthead gennaker halyard

• Fractional gennaker halyard

• 8x Spinlock clutches for halyards, mainsail reefs and bowsprit control lines

• Ronstan blocks and cleats for the mainsail, jib and gennaker control lines

• One tapered mainsheet with ball bearing low friction blocks

• Two mainsail reef lines

• Control line for the mainsail traveller

• 8:1 outhaul purchase led inside the boom

• 8:1 cunningham purchase

• 16:1 vang purchase

• Facnor LS70 jib furler

• 1x Spinlock clutch for jib furling line on the port side of the cockpit

• Three jib sheets

• 2:1 jib downhaulers with control lines, cleats and blocks

• Two tapered gennaker sheets with blocks

INTERIOR

• Bulkheads and furniture lightly covered with mat paint with white gel coat on the moulded parts for light, clean and low maintenance finish

Front Cabin: • Double V-berth with insubmersibility volume underneath

• Opening hatch of 25,5 cm x 25,5 cm / 10 inch x 10 inch for front cabin ventilation

• Faux leather cushion in GREY

Mid-section compartment:

• An opening hatch of 58 cm x 58 cm / 23 inch x 23 inch for light, ventilation and deck access to the mid-section compartment

• Sail locker panel in faux leather on the port side

• The base for chemical or flush toilet with monolithic reinforcements for valves on the starboard side

• Two faux leather foldable magnetic doors in GREY which are closing the toilet compartment

Saloon: • Open-space saloon area with large Plexiglass companionway washboard and sliding hatch

• Engine room cover with two ergonomically shaped wooden companionway steps

• Wooden benches on both sides of the saloon, divided into four covers of the storage space underneath, with Faux leather cushions in GREY

• Padded back-supports with storage behind the nets

• Berths in the stern on both sides, with insubmersiblity volumes underneath

• GRP boxes under the ceiling and under the companionway for electrical equipment

• Beige EVA foam floorboards

• Custom made well-insulated 25 L icebox under port cover, with fridge compressor upgrade possibility

• Indoor/outdoor foldable wooden table with storage bag in GREY

• Indoor/outdoor table attachment point on the top of the keel grid and on the cockpit floor

MECHANICAL AND ELECTRICAL

ENGINE

• Yanmar 2YM15 15 HP inboard diesel engine with shaft drive

• B-20 engine control panel

• 25 L / 6,6 gallons fuel tank with gauge

• Flexofold two-blade folding propeller, 14x11R/25

ELECTRICITY

• Custom electric control panel with five switches and smart Philippi LCD battery control display

• Remotely controlled master switches for service and engine battery on the control panel

• Standard 12V and USB plugs in the saloo

• 12V 70AH AGM service battery in the engine compartment

• 12V 70AH AGM starter battery in the engine compartment

• Ambient indirect LED lights around the ceiling

• One mid-section and two front cabin battery LED lights

• Masthead LED navigation and anchor lights

• Seanapps tracker to connect, monitor and control boat systems remotely on your mobile phone with a 1-year subscription

• Pre-wiring for most of the available electrical options

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.