Standing Rigging
ââ¬Â¢ Rod rigging - 2007 (Nitronic 15 Stainless Steel)
ââ¬Â¢ Hall double spreader spar
ââ¬Â¢ 1 main halyard, 2 spinnaker and 2 jib halyards
ââ¬Â¢ Harken roller furling with split drum
ââ¬Â¢ Vang-Master pneumatic custom vang
ââ¬Â¢ Navtec backstay adjuster
ââ¬Â¢ Harken winches, (replaced 2009) 2-#53, 2-#44, 2-#40, 1-#32
ââ¬Â¢ 1 carbon fiber spinnaker pole and 1 aluminum spinnaker pole
Otherââ¬Â¢ Over-boom deck and cockpit awning
ââ¬Â¢ Wood deck rails replaced with stainless steel deck rails 2007
ââ¬Â¢ 2 Fortress anchors, chain and rode (One has 18 ft chain and 150 ft rode. The other has 40 ft chain and 300 ft rode.)
ââ¬Â¢ 10 ft. West Marine dingy with high pressure inflatable floor
ââ¬Â¢ 3 ½ hp. Mercury outboard
ââ¬Â¢ Garhauer outboard engine crane lift system
ââ¬Â¢ 8 person Avon valise life raft last certified 2015
ââ¬Â¢ Mom 8A Man Overboard Pack - certified 2017
ââ¬Â¢ Life Sling
ââ¬Â¢ Cranker drill winch motor
ââ¬Â¢ Cockpit cushions
Instrumentsââ¬Â¢ B&G H 3000 CPU
ââ¬Â¢ 5 GFD displays including one at nav. station
ââ¬Â¢ 4 20/20 mast mounted displaysââ¬â¹
ââ¬Â¢ 2 analog wind point displays
ââ¬Â¢ 32 inch vertical masthead wind wand
ââ¬Â¢ B&G Zeuss2, 9 inch multifunction chartplotter/radar display
ââ¬Â¢ B&G 4G radar dome
ââ¬Â¢ Questas self-leveling backstay radar mount
ââ¬Â¢ B&G WiFi allows chartplotter display and control on iPad
ââ¬Â¢ Simrad RS-35 VHF with wireless remote control/mic & AIS receiver
ââ¬Â¢ Autohelm wheel autopilot with wired remote
Engineââ¬Â¢ Upgraded to SINGLE DIESEL 40 hp. 3 cyl. Yanmar 3JH4E (2007), approximately 550 hrs.
ââ¬Â¢ Gori 2 blade folding prop
ââ¬Â¢ Custom Cockpit Control Panel with Tach, Voltmeter, Oil Pressure, Temp, Alarm and Key Switch
ââ¬Â¢ 3 ½ hp. Mercury outboard dinghy engine (2010)
Tankageââ¬Â¢ Fuel: 30 gallons (aluminum)
- located under starboard settee
ââ¬Â¢ Water: 80 gallons (2 tanks)
1 - 45 gallons (aluminum) - located under aft berth
1 - 35 gallons (polypropylene) - located in the stern
ââ¬Â¢ Holding: 18 gallons with Tankwatch 90% full indicator light (polypropylene).
- located in the bow
Additional Information - 2017: installed LED LIGHTS in the V-berth
New dodger, JULY
Varnish redone- INTERIOR FLOOR (NOVEMBER)
- 2016: installed A/C & D/C PANELS (BLUE SEAS SYSTEM)
replaced wheel/helm canvas cover
replaced mainsail cover
installed 7 red/white salon dome lights (all LED, except 1)
- 2015: Varnish redone - ALL EXTERIOR
- 2012: replaced LOWER RUDDER BEARING with JEFA J-37 bearing
- 2010: Varnish redone - ENTIRE INTERIOR
- 2009: replaced ALL WINCHES
- 2007: Major REFIT :
- New upgraded engine SINGLE DIESEL (40 hp. 3 cyl. Yanmar 3JH4E)
- New deck paint, Waffle decking was sanded off and new rough decking paint applied.
- Removed & reset Toe Rail, All deck hardware removed and rebedded.
- Opening hatches and ports replaced. Replaced 9 opening ports.
- Replaced 2 20x20 Deck Hatches (Companion hatch not replaced)
- Instruments have all been upgraded.
- Keel bolts retorked.
- New Stanchions
- Replaced ROD rigging
- New back stay adjuster
NOTE- records available
Electricalââ¬Â¢ 3 Group 27 AGM 12 volt batteries
ââ¬Â¢ LED deck running lights, also masthead LED running lights
ââ¬Â¢ Mast mounted deck light
ââ¬Â¢ 7 red/white dome lights (all but 1 LED), 4 in main salon
ââ¬Â¢ 6 Reading lights-2 in forepeak, 2 in main salon, 2 in aft cabin
ââ¬Â¢ Blue Seas System A/C and D/C panels installed 2016
ââ¬Â¢ Xantrex multistage battery charger
ââ¬Â¢ KISAE 1000 watt invertor linked to boat 110 outlets with lockout shore power switch
Mechanicalââ¬Â¢ Diesel cabin heater
ââ¬Â¢ Propane Force 10 stove, 2 burner with oven
ââ¬Â¢ Isotherm Hot water heater - 4 gallons
ââ¬Â¢ Water: Pressure H/C, Cold foot pumps in galley and head
ââ¬Â¢ Norcold AC/DC refrigeration
ââ¬Â¢ 9 Opening Ports-all replaced in 2007
ââ¬Â¢ 2 20X20 Deck Hatches-replaced in 2007
ââ¬Â¢ 1 Electric and 1 Manual Bilge Pump
ââ¬Â¢ Emergency Tiller
ââ¬Â¢ Lower rudder bearing replaced with JEFA J-37 bearing in 2012
Sailsââ¬Â¢ Spinnakers, .5 oz. and .75 oz., Ullman
ââ¬Â¢ Carbon Fiber Main, Ullman
ââ¬Â¢Carbon Fiber #1, #2, and #3 Genoaââ¬â¢s, Ullman
ââ¬Â¢Daisy staysail/drifter
ââ¬Â¢FiberPath 140% reefable roller furling jib, Ullman
ââ¬Â¢Dacron 120% roller furling jib
ââ¬Â¢Dacron Storm jib
Running rigging All halyards are 3/8ââ¬ï¿½ Sampson Warp Speed which is a Spectra product. The afterguy is
7/16ââ¬Å, same material. Heavy and light spinnaker sheets.
Lines-
Afterguy- 1
Main halyard - 1
Jib halyard - 2
Spinnaker halyard - 2
Topping Lift - 1
Vang - 1
Outhaul 1
Cunningham 1
Reefing - Single line
defaultGeneral by Length
customContactInformationCONTACT LOCAL AGENT , CELL: 310 600-4055 KATHY
Email
Facebook
On LinkedIn
To Pinterest
Your Followers