Dimensions
Length at Waterline: 37.8'
Beam: 12.78'
Max Draft: 7.5'
Ballast: 7,250 lbs.
Displacement: 18,250 lbs.
Engines
Total Power: 56 HP
Tanks
Fresh Water: 90 gals in two tks.
Holding: 40 gals. in two tks.
Accommodations
Starting in the Forward Master, you have a large v-berth with storage below in two curved front drawers. This cabin also features a hanging locker, bureau, settee and private en-suite Vacu-flush head.
Aft in the Main Salon a large J/46 style varnished cherry drop leaf table with bottle storage compartment divides two equal settees that slide out to convert to sleeping berths. Excellent storage is provided out board of both settees. Above the starboard settee you also find a pilot berth and opposite to port the space was used to create more storage cabinets. The interior is finished in a "Herreshoff Style" with white flats and varnished cherry trim. The sole is varnished teak and holly. The galley is aft of the starboard settee and the large forward facing nav station is aft of the port settee.
The Aft Cabin is to starboard. This cabin has a double berth, vinyl siding, vanity with drawers and cabinet, full length shelf, and hanging locker.
Opposite to port you have the Aft head this head has a walk through to the cockpit storage locker, wet locker outboard of the head and jacket store behind the door.
Galley
The J-shaped galley is mid-ships to starboard. Her countertops have been up graded to corian.
- Three-burner Force 10 propane stove/broiler/oven
- Double S/S sink
- (2) 6 lbs aluminum propane bottles in cockpit propane locker
- Manual fresh water foot pump
- Large trash bin storage with flip-lid access under counter
- 6.5 cu.ft. icebox with dual hinged top, and internal acrylic sliding shelf/divider
- 12 volt Seafrost refrigeration
- Sharp microwave mounted under galley island facing nav station
- Dry goods storage bins outboard
- Griddle and pan storage locker under stove
- Flatware and utensil drawers
ElectricalWired for both 12 volt DC and 110 volt AC to separate panels with individual breakers.
- Four batteries connected in parallel make up the house bank.
- (2) Powertec AGM grp 31 batteries
- (2) Westmarine Seavolt AGM batteries
- Engine & Generator Start Battery
- (1) AGM Battery
- Xantrex Link 2000 monitoring system
- Master battery switch at nav
- Battery Isolator with parallel switch to allow engine start from house bank
- 125 amp Power Max alternator
- Fischer Panda AGTPM4 195 Amp diesel genset with auto start charging of AMG house batteries and sound silencing box.
- 30 amp shore power
- 50' Shore power chord
- 110 volt outlets GFCI protected
- (2) Inverters Xantex 400 KW and Xantex 2KW
- Galvanic Isolation protection
Electronics"RUMBA" has a very extensive electronics package.
- Shuttle brand CPU with a Pentium 4 processor 3 Ghz memory and 1GB of RAM
- Waterproof keyboard and dedicated inverter (separate from the Heart inverter for household 110 v. service).
- Mitsubishi Diamondstar V50LC 15-inch flat screen monitor
- Software- Windows XP and Nobeltec Visual Navigator v. 8.1.2 integrated with a Nobeltec radar on a post on the stern
- Sea Marshall Crewguard MOB alarm system with 6 necklaces (personal monitors)
- Cell phone antenna installed on stern post
- WIFI-Linksys GPC1 wifi card and external antenna
- Nobeltec Radar
- GPS input is from a Furuno GP-37
- Furuno GP-37 GPS-WAAS at nav B&G Hercules 2000 with performance processor onto which polars are burned from the USSA performance package for this boat.
- (1) B&G multipurpose readout at nav station
- (3) B&G multipurpose and (1) B&G 20/20 mounted on pod above companionway and 20/20 controllable from helm
- North Star plotter 6000i with New England Navionics charts mounted on custom bracket at helm
- Grundig YB 400 PE SSB/LW/SW receiver and SSB antenna on backstay; feeds computer for weather
- ICOM IC-M502 VHF with transmit/receive mike in cockpit
- B&G autopilot with remote control
- Sony EQ7 Tuner/CD/Cartridge player feeding main cabin speakers (Can also play movie CD's through computer screen).
Mechanical- Yanmar 56 hp 4JH3-E, fresh water cooled, 4 cylinder, naturally aspirated diesel engine
- Saildrive SD-50
- Gori two-blade, geared folding propeller
- Fischer Panda AGTPM4 195 Amp diesel genset
- 52 gallon aluminum fuel tank
- Racor fuel filter
PlumbingHot & cold pressure water system with hot water tank and accumulator tank.
- Seagull carbon filter water purifier
- Self-priming direct sump pump for shower draining directly overboard
- Salt and fresh water manual pump in galley
- Salt water anchor washdown
- Automatic bilge pump with float switch and dedicated panel in nav station wired direct to DC system
- Manually operated bilge pump mounted in the cockpit
- 50 gallons of water standard in custom molded tank with baffles, inspection port, and secured in place below starboard main cabin settee berth
- Additional custom 40 gallon aluminum water tank mounted below starboard quarter berth
- Xintex fresh water and holding tank monitoring system
Hull & Deck"RUMBA" is built by SCRIMP infusion molded sandwich construction using biaxial, triaxial and quadraxial E-glass with Baltek Super-Light 45 end-grained balsa core in the Hull and Deck. Vinylester resin throughout all GRP components.
She features a new 2008 AWL-GRIP "White" hull with custom 1 inch white hull/deck radius rubrail stripe and white transom, Blue boot stripe and Blue cove stripe. The decks are white gelcoat with buff non-skid. The builder added to her hull an extra laminate to insure a brilliant finish and minimize print through.
- TPI 5 year structural warranty with 10 year transferable warranty against hull blisters
- Lamination specifications to exceed ABS offshore yacht standards
- ORC height foredeck toe-rails integrally molded into deck forward of mast
- Stainless steel handrails on cabin trunk
- Bow locker with deck hatch and overboard drainage
- Two lazarette lockers on afterdeck
- Molded structural grid infused to hull for a primary bond to hull shell. Grid includes keel floors, mast step, engine bed and longitudinal supports
- GRP molded main structural bulkhead, bonded with epoxy to the hull and deck
- Molded companionway seahood with integral instrument pod, molded slider and acrylic drop board equipped with inside/outside stainless hasp and storage rack in cockpit locker.
- Molded stern boarding/swim platform with boarding ladder
- Molded propane locker to starboard, vented & drained overboard
- SSB molded ground plane
Deck Hardware- (2)Harken 60.2 AST self-tailing, 2 speed primary winches
- (2)Harken 48.2 STA self-tailing, 2 speed mainsheet winches
- (2)Harken 48.2 STA self-tailing, 2 speed, secondary winches mounted on the cabin trunk
- Port halyard cabin top winch is electric.
- (2)Harken 46.2 STA self-tailing , 2 speed forward halyard winches
- Lock-in winch handles with (4) PVC winch handle holders
- Harken ââ?¬Å?Black Magicââ?¬ï¿½ blocks for reef lines, spinnaker and genoa blocks
- Harken stainless ââ?¬Å?ESPââ?¬ï¿½ halyard and reef blocks at mast collar
- Spinlock rope clutches for halyards, reef lines, furler line, and tack line
- Harken mainsheet and traveler system with Black Magic series blocks & components
- Harken adjustable jib/genoa car system with purchase system led to the cockpit
- All shrouds have been mounted outboard to eliminate rod below decks and to facilitate easy jib handling
- Midship pad eyes mounted outboard
- Double turning blocks for spin sheet and checkstays
- Stainless stern and bow rail
- Custom extended and upgraded anchor bow roller fitting to accommodate Spade anchor and fitting for gennaker
- Tapered lifeline stanchions with amidship boarding gates port and starboard
- (4) 10� mooring cleats
- (3) articulated, acrylic Gebo hatches with screens
- (9) Gebo opening ports and one fixed port (over Nav station) on cabin trunk with screens
- (2) Gebo opening ports with screens in cockpit well, one each for port and starboard aft cabins
- (2) custom dorades
- Telescoping transom swimming ladder
- Custom folding dinghy davits on stern
- Stainless mast collar with fastening points for halyard blocks
Sails, Spars & RiggingHall Spars pre-preg black carbon fiber mast autoclaved at 80 PSI at 250 deg F. Mast includes double airfoil aluminum spreaders, carbon gooseneck, black Awlgrip finish, painted white bands, wire runs in conduit, Antal mainsail track for #40 cars with loader and end fittings to accommodate sailmaker provided mainsail sliders and/or boltrope.
Hall Spars boom of 6061-T6 aluminum with black Awlgrip finish, welded gooseneck fitting, lug for boom vang, internal 12:1 mainsail outhaul with external cleat, bale for mainsheet block and painted white bands.
SAILS *North Marathon main with Dutchman furling rig and Antal sliders, *North Marathon furling 105% jib, *North 3DL racing 108% jib non-furling with horizontal battens and deck sweeping, *1.7 oz North A2 gennaker with snuffer, *North Stay-sail.
- Hall D-30 QuikVang
- Harken MKIII Unit 2.0 furling system with airfoil performance extrusion, corrosion proof spool and drum, tapered torque tube, AirSwivel for reduced weight aloft, cast aluminum Hardcote anodized chafe guard, and low stretch adjuster line.
- Custom Navtec continuous rod rigging and turnbuckles mounted outboard of standard location
- Sailtec integral hydraulic backstay
- Carbon fiber whisker pole mounted on mast with extended track for mast storage and ease of jibing
- Inner forestay box w/ internal sheave halyard and checkstay tangs
- Kevlar Inner forestay with Wichard lever
- Second main halyard sheave for Dutchman mainsail furling system
- Sailtec integral hydraulic backstay
Additional- Espar Heating System
- Linen Sunbrella Thurston cockpit dodger with roll-up forward window & removable side curtains
- (4) 16x24 polypropylene mesh line bags
- White vinyl helm and cockpit cushions
- Custom removable varnished teak cockpit table with two fold out leafs, removable table leg and a padded bag to protect the table when stored below
- Cockpit Shower on swim platform
- Lee cloths for 3 main cabin berths. Spade 160 anchor with chain and rope rode
- Life sling
- (4) fenders and (4) docklines
- All manuals and engine spares
- Bookcase mounted on forward main cabin bulkhead
- Full "Fair Clough" custom winter cover with frame
- (3) Individual Sumbrella covers for Wheel, GPS, and Compass
DisclaimerThe Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Email
Facebook
On LinkedIn
To Pinterest
Your Followers