Accommodations
All the way forward is a full width double V berth measuring 6�4� from head to toe. There are storage drawers under the berth. On the hull sides there is storage for each of the two dinette fillers. In the overhead there is a large opening hatch with custom screening and sun shield. There is a filer for the V berth. Aft of the forward stateroom on the port side, there is a complete galley. See the below for full specifications.
To starboard of the galley is the enclosed bath with a pull around shower curtain. Going aft and up two steps is the main salon. The wrap around windows permits 360 degree visibility that even permits harbor viewing while dining. To starboard is the lower helm station. At the helm station there is a helm chair to use while under way in inclement weather.
On the port side of the salon is a settee that converts to a double berth. The settee serves a large Custom Teak Veneer table that will easily handle four for dinner. There is also Newer Carpet in the Salon and forward cabin.
There is an aft cockpit with bimini top with a lazarette hatch, transom door and a fiberglass swim platform. From the cockpit there is a ladder up to the fly bridge. That area furnishes three helm seats and a full electronic package.
Galley - Nova Cool Refrigerator, 12V/110V
- Force Ten two burner Propane Stove with cutting board cover
- Microwave
- Stainless Steel Sink
- Plenty of drawer and cabinet storage
- Pressure water system
- Force 10 Hot water heater, both 110 and engine heated
Electronics and Navigation - West Marine VHF at upper helm and ICOM VHF at lower helm
- Garmin 5212 Chartplotter/Radar atUpper Helm and a Garmin 5208 at the Lower Helm
- Garmin Depth and Speed on the Chart-Plotters
- Garmin Autopilot at both Upper and Lower Helms
- Stereo with CD
- Ritchie Helmsman compass on the Fly-Bridge and a Saturn compass at the lower helm
- Bow Thruster controls at both helms
Electrical and Mechanical - Westerbeke 5KW 1800 RPM 3 cylinder Generator, new impeller Nov. 2018
- Xantrex 1000 Inverter
- NEW November 2018 Mastervolt 40 amp Battery Charger
- Three Group 27 House Batteries
- NEW 2018 Group 27 Engine Start Battery
- Katadyn Power Survivor 80 E Watermaker (may need new element)
- Cruise Air 16000 BTU Reverse Cycle Air Conditioner with NEW 2018 raw water pump
- Jabsco Electric Head
Engine and PerformanceEngine access is beneath the main cabin, and the overly-large hatch permits easy engine access to both the main propulsion and the generator.
- Volvo 200 HP TAMD-41 Diesel with only 2565 hours
- Reported cruising speed is 7.5 to 8 Knots burning 1.5 gallons per hour. But she will get up to 13 or 14 knots if you need to get out of the weather
- Kobelt engine controls, upper and lower
- Hydraulic steering with NEW 2015 ram drive
- Dripless shaft seal
- Racor 500 Fuel Filter
- All hoses replaced or inspected
Deck and Hull - Lift kept by the last two owners
- The hull is hand laid fiberglass with Core Cell foam in the deck house. All floors have two layers of sound bleeding insulation
- Bottom was Barrier Coated and bottom painted in 2014 and no blisters
- Sunbrella Bimini top, Aft Deck Bimini and upper helm cover
- The propeller is a four blade bronze prop protected by a full skeg beneath the prop.
- 5 HP Electric bow thruster with controls at both helms
- Lewmar Pro Series Electric Windless (2nd. generation upgraded)
- 15kg Claw. Anchor with 30� feet of chain and 150� of rode
- 7.5 kg Bruce with 15' of chain and 100' rode as a secondary anchor
- Three windshield wipers at lower helm area.
- Diamond Sea Glaze on Main Door
- Diamond Sea Glaze on all windows that all have sun screens
- Transom Door
- Fiberglass Swim Platform with swim ladder
- Dinghy Hauler® model 6000 Davit mounted on swim platform, no dinghy available
- Hot & Cold Cockpit Shower
- Bronze Ball valves on all underwater fittings
- Bridge Clearance is 15.0' with the bimini, with the radar mast up it is 25.0'
Manufacturer Provided DescriptionThe Camano 31 Trawler with a flybridge that includes three pedestal seats, an adjustable center seat with slider, and a stainless steel steering wheel. Built in British Columbia and designed for this coast, an area well known for high quality boats, the Camano 31 was designed by Bob Warman to meet the demand for a boat with a comfortable 12-knot cruise speed that retains a high resale value. With a 10-foot 6-inch beam for stability and 5 feet of freeboard at the bow, weather is not going to threaten this boat. The Camano 31 runs well over 18 knots with a single 200 hp Volvo Diesel.
The interior offers the same usable room as many 33-foot production boats and is much easier to handle. With the standard bow thruster one person can dock the boat even in very tight spots. The Camano features an open cruising layout (salon and aft deck on the same level), with a full-size bridge. The open, bright interior provides great visibility from any part of the seating area with its picture window view. The interior is light and friendly. Cabinets and trim are mahogany, the cushions are covered with premium fabrics and the floor is either oak or carpeted. Accommodations are as open as possible - the salon measures 8-feet, 10-inches by 10 feet and is on the same level as the aft deck which is 40 square feet. The galley and head are half a level down; with a U-shaped galley out of the traffic area but still open to the salon. With a large counter area extending under the side decks there is lots of room for full-sized stove with oven, refrigerator, microwave, and large sink. Storage space is provided including dish locker outboard of the fridge. The shower is built in as a part of the head area. The dinette easily converts to a double berth while the forward berth has a filer available to make a double.
The Camano 31 comes well equipped with 110-V dockside package, pressurized hot and cold water at the galley, depthsounder with speedometer and log, VHF-radio, AM-FM stereo cassette radio, and 17 lb. Bruce anchor with lead chain and rod. The Keelform hull is the result of a science program of the University of British Columbia and Camano Marine. Keelform is a unique bottom shape with large displacement keel and very wide waterline beam. Test results show almost no planning angle change or "hump" in the horsepower curve between displacement and planinng speeds which, in the case of a boat this size, is between 7 and 15 knots. While most semi-displacement boats are straining and reaching their horsepower limit, the Camano is cruising comfortably up to 18 knots. The hull reduces fuel consumption in the most widely used speed range - between 12 and 18 knots; runs 19 - 20 knots top speed, with a single 200 hp Diesel engine; and provides a smooth, dry ride in rough water because of a special flare in the bow section. Engine failures are extremely rare with Diesel engines and if they occur, 99 per cent of all cases are due to contaminated fuel. Commercial boats and fishing vessels which operate year-round in all kinds of weather conditions usually have only one diesel engine.
Most boat builders whose brochures mention "hand-laid fiberglass" use chopper guns to replace the traditional fiberglass mats by "chopped strand," which are only two-inch long glass fibers wetted with resin by the "chopper gun" and sprayed into the mold. Only the woven roving are rolled or "laid in" by hand. The hull of the Troll is 100 per cent hand-laid, with no "chopped strand," and thicker than the hulls of comparable production boats. The boat has a heavily built, very strong inner liner laminated into the lower portion of the hull; the bulkheads are thoroughly laminated into place from both sides as are the other parts of the interior. The impact and tear strength of a Camano hull is ten times higher than most production boats. Running aground with the Troll is not a problem. Prop, prop shaft and rudder of the Camano are protected by a heavily reinforced skeg and keel shoe. The inboard diesel combined with the electric bow thruster result in a handling advantage even over twin stern drives.
DisclaimerThe Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
customContactInformation For Additional Information Contact Joe or Ron
Joe Maggio 941-740-0871 E-mail joe@pieroneyachtsales.com
Ron Vendegna 941-916-2740 E-mail ronv@pieroneyachtsales.com
Email
Facebook
On LinkedIn
To Pinterest
Your Followers