Condition
Over the past 2 years, the following have been replaced/updated:
Two Ray-Marine AXIOM multifunction displays with GPS antenna, dual transducers (3D, side view), all network interconnected.
Flybridge's console was modified by converting Tiara's original flat face non-angled console into an angled view, providing more easily viewable electronics and increasing available surface area for additional installations.
Flybridge's console was also modified with a larger custom door for better accessibility to the console's professionally installed electrical wiring.
VHF radio and AM/FM/CD player/USB marine radio
The Berth floor was redone with a customized hatch that generated an increase of space for anchor/ropes, which did not exist in the original Tiara setup.
Transformation of the main salon floor customized to connect floor panels to the boat structure by hinges. Along with installing lock support to the hinged panels to keep them in an open position.
Original Tiara's floor was removed to obtain access to the engine room.
Head:
Shower head and lighting in the head. Faucet valve with spray hose in the head. Vacu-flush toilet and vacuum pump rebuilt.
The Galley sink valve and soap dispenser were replaced with a large remote container installed.
Carbon Monoxide detection device installed.
AC unit salon area with electronic control
AC pump
Original aluminum A/C grills replaced by top-quality decorative plastic ones
. Air Conditioning:
Replacement of existing A/C water intake strainer with a new oversized one
Thru hull fittings
The valve and hoses for the AC pump intake were replaced for the new size.
All AC raw water hoses in and out of the two AC units were replaced.
Fresh water pump
Freshwater system pressurized tank installed.
Battery charger
Inverter and two dedicated batteries keep the refrigerator and freezer on while at anchor without the need for generator usage.
The Holding tank was appropriately sized to remove it if necessary to work on the space of the port engine. The original tank needed to be taken out in pieces to remove it from the location.
Holding tank vent filter
All black water hoses were replaced with high-quality sanitary hoses and quick connectors for easy removal if access to the port side of the engine and/or to the vacuum pump is needed.
Quick connect caps would close up all disconnected hoses to avoid contamination.
Gen-set had complete maintenance, all hoses replaced, as well as the water pump and wiring.
CAT engine's air intake system was professionally redesigned with new Walker Airsep air filters relocated to a better place.
CAT engines replaced wiring
Trim tab's hydraulic pump, relay, control switch, etc
Trim taps plates and hinges made of 316 stainless steel installed.
Raw waterpump, strainer and hoses
Cockpit fresh and raw water hoses accessed by dedicated hatches.
Cockpit freezer mounted in a removable bracket.
GFI circuit with dedicated line installation in the cockpit.
The cockpit floor fish tank draining system is controlled by three separate mechanical switches that evacuate the floor tanks and baitwell by the suction of a new diaphragm pump installed.
All three mechanical switches are located in an accessible place on the transom, in front of the floor tanks.
In the areas where the boat had the walls covered by upholstery, the upholstery was removed, the fiberglass walls were sanded and painted, and the areas were customized (preference for aesthetics and easy cleaning). Upholstery could easily be reinstalled if wanted.
Stern lights were installed.
Rod holders (8) installed
All upholstery was replaced in the flybridge and transom back cushion with the Tiara logo.
Salon curtains
12v high amperage terminal blocks all places
Racor fuel-water separator for generator
Exhaust hose generator
Shower sump pump
The sump pump floor area was modified. Installation of extra-large reinforced floor hatch for easier access to the sump pump.
Engine room customized removable aluminum floor plates between engines were installed.
Engines heavy-duty stainless steel brackets installed.
Both shaft seals were replaced.
Both shafts straighten
Both propellers were balanced.
Engine room lighting
Both engines and gen-set had fresh paint.
Reinforced customized stainless swim platform brackets installed.
Large bait/fillet cutting board customized with a strong, stainless steel bracket allowing easy relocation of the board from the port side to the back of the transom.
St. Croix davits with factory-customized stainless brackets
Navigational Equipment
- Compass
- Covers - Display
- GPS/ Fishfinder/ Plotter (2)
- Masthead Light:
- Navigation Lights
- Radar Dome
- Side Scan Sonar
- Tower Light
- VHF
- VHF Antenna
- VHF Speaker
Mechanical
- Bilge Blower
- Bilge Pump
- Engine Alarms
- Holding Tanks
- Throttle/shift: Mech
- Trim Tab Controls
- Trim Tabs
- Turbocharger
Electrical Systems
- 12 V DC Outlets
- Batteries ( Number Of) (6)
- Battery Switch (2)
- Bluetooth
- Cockpit Accent Lighting
- Courtesy Lights
- Docking Lights
- Fuel Gauge
- Fuse Panel
- Hour Meter
- Inverter
- Iphone AUX Plug-in
- Oil Pressure Gauge
- Shore Power
- Shower Sump Pump
- Smartcraft System View
- Speedometer
- Stereo
- Tachometer
- Underwater Lights
- USB Port
- Volt Meter
- Water Heater
- Water Pressure Gauge
Accommodations
- Cabin Lighting
- Cabinets
- Dinette
- Fridge/freezer- Full Size
- Head
- Microwave
- Mirror
- Port Holes
- Salon
- Shower
- Sink - Galley
- Stove
Construction
- Bottom Paint Antifouling
Deck Gear
- Anchor
- Bait Well (With Interconnected Drain Plug)
- Beverage Holders
- Bow Rail
- Captain's Chair
- City Water Hookup
- Cleats - Fixed
- Compartment Storage
- Davits
- Freshwater Washdown
- Helm Light
- Live Well
- Net Holder
- Outriggers
- Pedestal Seats
- Rod Holders
- Rod Storage
- Rub Rails
- Steering Wheel
- Swim Ladder
- Swim Platform
- Transom Door
- Windlass
- Windlass Locker
- Hard Top
Safety Equipment
- Carbon Monoxide Detector
- Engine Kill Switch
- Fume Detector
- Grab Rails
- High Bilge Water Alarm
- Horn
- Owner's Manual
- Spotlight
- Sump Pump
Email
Facebook
On LinkedIn
To Pinterest
Your Followers