Engine & Mechanical Systems
Fully rebuilt, repainted & restored Yanmar 315hp 6LPASPT2 engine (i.e. new hoses, belts, decals, stainless steel exhaust elbow, etc.) w/ 320 hours
- Yanmar gauges/ lights, etc.. carefully and elegantly integrated into helm
- Custom fabricated engine belly-pan below engine w/ new oil absorbent mats installed below engine
- NEW Shaft, strut, prop aligned with new propulsion Ã?Â
- Engine & VF Transmission have been fullyÃ? serviced byÃ? List Marine, Sausalito, Ca . Oil sent out/ analyzedÃ? Ã?Â
- NEW Barry Marine engine mountsÃ?Â
- Engine-room Fire Suppression by FireboyÃ?Â
- Newly serviced Kidde-10 Marine (white) fire extinguisher located under companionway stepÃ?Â
- Two (NEW) AGM Commercial Batteries by Arc Batteries (Group-4D, type-2, 190-AH, 12-Volt)Ã?Â
- Jabsco Main Bilge Pump (Model 36600), custom and elegant installation w/ activation light wired to main panelÃ?Â
- NEW Rule 360GPH forward bilge pump w/ Rule (NEW) float switch w/ activation light wired to main panelÃ?Â
- NEW Jabsco saltwater wash-down pump (32605) integrated into cockpit, and activated via main Bass panelÃ?Â
- NEW Racor water/ fuel filter separator w/ clear glass bowl
- NEW ARG Raw Water strainerÃ?Â
- NEW Packless Sealing System by PYIÃ? Ã?Â
- NEW Espar Heater (by Eberspacher), integrated with main diesel fuel tank & custom starboard exhaust outlet, four registers (two in helm area, one in head & one in v-berth area)Ã?Â
Hull & Deck Equipment - NEW Manship stainless steel front hatch
- Marinco windshield wiper motors with 'self-park'Ã?Â
- Custom fabricated Soundown curtains in engine compartment + Soundown engine box mats, pinned to surfaceÃ?Â
- Custom built solid teak helmbox with integrated Simard (autopilot, plotter, radar), Side-power updated bow thruster control, Lenco trim-tab switch + ICOM VHF handset plug, Lewmar Windless V700 switch each mounted on a custom fabricated piece of stainless-steel... Additionally, top-mounted vintage Morse control & 'start' & 'stop' buttonsÃ?Â
- Fully serviced and cosmetically restored bronze Seacocks
- NEW Custom fabricated solid bronze running lights (located on port/ starboard side of windshield), and anchor/ steaming light (located on solid teak radar mast)Ã?Â
- NEW Edison leather-wrapped stainless-steel destroyer helm wheel
- NEW Awlgrip painted hull, and (white) boot-stripe & custom gold-leaf painted name & hail-port (transom)Ã?Â
- NEW Teak swim-platform & undermount Windline stainless-steel ladder w/ Windline strapÃ?Â
Interior & Canvas - Restored Perko lights with half-shades (galley, head & v-berth)
- All dashboard, companionway top(s)/ doors, cockpit sole, engine cover & nonskid decks painted in AwlGrip (flat white & moondust, respectively)Ã? Ã?Â
- NEW Sunbrella tan canvas for soft-top, windshield cover, bow pulpit/ windless/ front hatch, helm box, rear bench, etc. by OKTO Canvas & Sausalito Canvasworks
- NEW 60m polycarbonate windshield panels (x2) by Sausalito CanvasworksÃ?Â
- Sunbrella navy cushions w/ red piping for rear bench, engine box, helm-seat, passenger seat., v-berth & v-berth insert by OKTO CanvasÃ?Â
- NEW Classic stainless steel lever galley pump by FynsprayÃ?Â
- NEW Freshwater flexible bladder tank elegantly installed under v-berth w/ integrated (stainless steel) fill valve on deck
- NEW Custom designed mahogany galley w/ integrated (flush-mounted) icebox lid actuated by a stainless-steel gas strut, flush-mounted mahogany galley basin top, integrated enamel plates, bowls and silverware, as well as custom-designed storage compartment behind stainless galley basin, and adjacent to integrated silverware location. Additionally, paper-towel mount is located above plates & bowls. Lastly, galley cabinet (below) galley sink includes two custom shelves (1-w/ mahogany end-cap, satin finish), and additional storage under lower shelf
- Custom-fabricated vintage solid brass porthole installed in head w/ two solid brass dog-ears to secure
- NEW Custom (authentic) teak-holly floor in galley/ head & below deck
- Forward and main bilge compartments cleaned/ detailed & epoxy-painted in advance of any electronic installationÃ?Â
- NEW Whale V-Pump (MK.6) Stainless Steel Pump for Ice-box sump
- NEW Stainless-steel galley sink undermount basinÃ? Ã? Ã?Â
Electronics & Electrical - Simrad NSS8 w/ integrated radar, chart-plotter/ GPS, eco-sounder, SIRIUS weather & Autopilot + Micro-SD card reader (i.e. Navionics or InsightHD)
- Simrad Autopilot w/ integrated compassÃ?Â
- Side-Power Bow Thruster (SP 55S)
- EEL Shorepower (w/ thoughtfully placed outlet in starboard cockpit area)Ã?Â
- Lenco Trimtabs (integrated at helm) w/ custom-made (from Dyer Boats) transom bracketsÃ?Â
- Engine-room Fire Suppression by FireboyÃ?Â
- NEW Icom VHF Commander (remote-mount on aft side of teak helmbox)Ã? Ã?Â
- Yanmar warning panel/ lights thoughtfully integrated into aft side of teak helm stationÃ?Â
- NEW VDO (backlit-red) gauges, i.e. RPM, Voltage, Water Temp, Oil Pressure, Fuel level (x2 tanks)
- Fusion Bluetooth Stereo (MS RA205) fully updated, w/ four JL Audio waterproof cockpit speakers & remote
- NEW Freedom (HF Series) Inverter/ Charger w/ elegantly, thoughtfully integrated remote in galley cabinet under stainless steel galley sinkÃ?Â
- Power outlet located on headboard of port v-berth Ã?Â
- NEW Veethree Hourmeter gauge, installed in head
- NEW JF Johnson High Water Alarm switch (located in head)
- NEW Custom-designed Bass panel. All switches/ breakers thoughtfully labeled and back-lit (red) with analog (illuminated) gauges, and custom-designed Dyer-29 flushdeck imprint w/ integrated LED lights for fwd & main bilges, as well as running/ anchor lights. Additionally, panel includes several 'spare' breakers, and pre-labeled breakers for items like an electric head, etc.. Panel is encased in teak with a plexiglass protective doorÃ?Â
- Custom-design and perforated child-door for v-berth (perfect for kids and/ or babies during nap-time); presently secured to galley wallÃ?Â
- Herreshoff-style tongue & groove hull-sides and headliner painted white & secured with (individually aligned) brass screws
- NEW BEP/ MasterVolt/ MarinCo (720-MDO) high current motorized breakers (3x) thoughtfully installed (flush) beneath companionway step
- Lewmar V700 Windless flush mounted to bow w/ 20ft of Stainless-Steel chain, stainless steel universal mount, 25lb Suncor Stainless Steel (polished) plow anchor & 250ââ?¬â?¢ Ã?½ââ?¬ï¿½ nylon rodeÃ?Â
- Windless is wired to the main Bass panel, and an elegantly designed (Stainless) remote switch is located on the aft side of the helm boxÃ?Â
- Custom Stainless-Steel flashing was fabricated below, inside and above varnished teak bow pulpit w/ integrated locking pin for anchorÃ?Â
- Teak bow pulpit also includes a stainless mount for solid-teak burgee poleÃ?Â
- Solid teak burgee pole for placement for placement at end of bow pulpitÃ?Â
- Solid teak radar mast includes custom fabricated stainless-steel deck mount, radar mount, VHF antenna mount & solid bronze steaming/ anchor lightÃ?Â
DisclaimerThe Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
customContactInformationââ?¬Å?To give real service you must add something which cannot be bought or measured with money, and that is sincerity and integrity.ââ?¬ï¿½ ââ?¬â?? Douglas Adams
We are always in search of quality vessels to list, so if you are thinking about selling or upgrading, please email us to discover the difference that is Latitude Yacht Brokerage:
Ryan J. Miller
Yacht Broker / Owner / U.S.C.G. Master Capt.
401-835-0069
ryan@latitudeyacht.com
See what we are all about:
www.latitudeyacht.com
Email
Facebook
On LinkedIn
To Pinterest
Your Followers