.
OWNERS VERSION TRU32 POWER: 2 FORWARD SLEEP CABINS, 1 AFT SLEEP CABIN, HEADS AFT ON PORT / LEFT SIDE, GALLEY MAINLY UP IN SALOON, OR DOWN IN PORT HULL.
The cost of this version as a standard TRU32 POWER is US $ 225 000 excl Sales Taxes
Note: the price is based on delivery ex factory at the TRU32 factory in Atlantis, Western Cape, RSA.
All pictures are a sister-ship and provided by TRU32
MEASUREMENTS:
- Length overall: 32 foot, [9.75 meters].
- Beam: 16 foot 4 inches [4.99 meters] {Note, a TRU32 will fit in a standard marina based single berth}.
- Draft: 2 feet 8 inches [850mm]
- Bridge Clearance: 13 feet [3.96 meters]
- Weight, unladen approximately 5000 Kgs, 5 tons.
- 350 Liter diesel tank mounted mid-ships under saloon floor area. Includes fuel filler system, filters and breather pipes.
- 200 liter water tank mounted forward lockers with filler point by forward deck step.
- Black water holding tank and maceration pump, 160 liters.
ENGINES:
- VETUS 2 X Diesel [VOLVO] 27hp engines with filters, sail drive and standard propellers, mounted on absorbed based engine beds in easy access aft compartment.
- Wet muffler type exhausts with water flow back locks.
- 2 X Controls including throttles, dials, feedback information, mounted on helmsman’s control console by double helmsman’s bench.
INSTRUMENTATION – All Garmin:
- Garmin wind, speed and depth gauge with single screen toggled readout mounted at helmsman’s control console.
- VHF 422 with masthead aerial.
- CD/DVD/MP3/Radio player with speakers mounted in Saloon and overhead in Targa legs.
INTERIOR:
The interior of this version consists of two forward cabins each with double beds, wash basin with H&C, lockers and cupboards, one aft double bed cabin on the starboard, right hand side with lockers and a Heads consisting of toilet, washbasin and shower in the port, left hand side aft cabin.
- Covering to the ceiling of the saloon and part of all sleep cabins in a low gloss ‘headliner’. Headliner in ‘Heads’ cabin in low gloss finish
- The beds in the forward cabins are low mounted and run fore to aft to give easy access.
- All cabins are accessed by lockable, framed, lightweight wooden doors.
- Wood paneling to the sides of all cabins in light wood such as Beech or light oak for easy cleaning finish. Sides of ‘Heads’ cabin in low gloss waterproof paneling.
- The Heads consists of a toilet with electric flush, wash basin with H&C and shower with mixer tap. The shower drain pump is automatic. Waterproof lockers are included.
- All cabins and walkways except the heads have multi-coated marine ply flooring. ‘Heads’ in GRP molding with wooden shower floor.
- Built in cupboard unit in port hull with sliding doors. Built in cupboard unit in starboard hull area with drawers.
- Built in 90 liter top loading fridge and separate freezer in starboard hull from National Luna.
- Saloon area has wrap around seating with seats covered in selected easy clean fabric. Pull out drawers under each seating unit, pulling into the hull area.
- Saloon table with ‘galley’ matching top and fiddles.
- Galley unit in saloon area of SS bowl, fold down H&C tap set with cover over sink area. Preparation area, 3 burner gas hob with cover over. Or Galley can be in Port hull area giving more space in the saloon
- The galley unit also has storage, built in trash bin, and cupboards.
LIGHTING:
- All lighting based on a 12v system even if a 110/220 Ac system is specified as an alternative option. [Safety considerations].
- 1 LED down light in each cabin
- 6 LED down lights in Saloon area
- 4 LED down lights built into Targa covering the cockpit and the Al-fresco deck.
- Underwater lights in stern of hull by sugar scoops. [Gives a great lighting impact].
- Swivel reading lights – 6 in total, 2 per sleep cabin.
ELECTRICAL:
- 1 X 65 amp starter battery per engine.
- 2 deep cycle batteries totaling 210 ah for house supply.
- 1 battery switch.
- 1 custom switch panel and distribution board.
- 1 12 volt outlet at switch panel, [in saloon].
- 1 AC outlet at switch panel, [from shore supply unless inverter fitted].
- 1 AC outlet in Galley, [from shore supply, unless inverter fitted].
- AC panel 110 or 220
- DC Panel
- Gas / propane solenoid cut off regulator. Gas bottle located in forward draining locker and piped thru to 3 burner gas unit in Galley.
- Connection point on deck for AC shore supply.
PLUMBING:
- Electric toilet, large bowl
- Mixers with shower outlets in heads.
- Shower drain pump.
- 200 liter water tank mounted forward lockers with filler point by forward deck step.
- 15 ltr, water heater for hot water system.
- Mixing taps in Heads, Galley and both forward cabins with H&C.
- 1 Bilge pump in each hull with float switch.
- 1 manual bilge pump in each hull with controls in cockpit.
- Black water holding tank and maceration pump, 160 liters.
- Water filtration system for pressurized drinking water and foldaway tap in the sink in Galley.
HULL, DECK AND BULKHEADS:
Constructed to accepted designer specifications and standards utilizing:
- Resin approved by Lloyd's, SABS and ISO9002.
- Gel-coat approved by Lloyd's, SABS and ISO 9002.
- Lloyd's approved balsa core applied in stress points such as cabin roof, Targa etc.
- Chop strand mat and a stitched quad axial mat approved by Lloyd's, SABS and ISO9002.
- All reinforcing points around such as chain plates, cross beams, winch points are triple layered for strength.
- All bulkheads are glassed into the hull and deck creating strength and water tight compartmental points forward and aft.
- Non-skid surface at walkway points and tracks applied to deck.
- 2 X coats of International anti-foul.
- 4 Layers Inter-Protect rolled over Gel-coat below waterline for osmosis protection.
FLY BRIDGE / UPPER DECK:
- The Flying Bridge or “Upper Deck,” is the Targa that has been extended to cover part of the cabin roof area. At the rear of the Upper Deck is a slanting wing in alignment with the Targa legs to provide design harmony. The slanting wing incorporates a mast containing such as Radar, lighting, cameras, etc. The slanting wing also holds seating for upper deck passengers. The twin sun-beds are also incorporated into the upper deck as well as a much lower forward positioned slanting wing to reduce wind-age and ensure passenger comfort. Along the sides of the upper deck are clear view toughened Perspex and stainless steel shielding acting as protection and decoration. Access to the Upper Deck is provided via a double pole ladder from the cockpit, just behind the helmsman’s position and protected by a fold back and lockable hatch cover.
- Safety railing and spray protection railing on sides of flying bridge and Targa sides.
DECK FITTINGS & FEATURES
- Deck Cleats X 6 some with fair-leads for shore mooring.
- 1 X Compass mounted at the Helmsman’s control console.
- Water and fuel filler fittings on deck.
- 8 hatches, [2 forward stowage lockers, 2 forward cabin hatches, 2 hatches in saloon, 2 side hatches in aft cabins].
- 6 side port-lights non-opening.
- 1 fully anodized, large sliding and lockable sliding door to saloon from cockpit.
- Large 10mm acrylic windows for sides and forward view from saloon and forward cabins.
- Sound horn.
- Outside cushions for cockpit.
- Cushions for beds on Upper deck.
- Targa support poles, large aft pole to Al Fresco deck, two forward poles to cabin roof, single helmsman’s grab pole by seat.
- Helmsman’s seat as a double padded seat with movable backrest in serious comfort level.
- Grab handles on cabin roof.
- Grab handles on Targa roof.
- Pulpit railing with side seats with seats in wood.
- Push-pit aft rail complete with lifting seats with seats in wood.
- Sugar scoop step rails.
- 1 Alfresco dining table, with drop sides
- 8 Stanchions with top solid rail and second safety lines using shackles and bottle screws.
- Fold up boarding ladder in sugar scoop.
- Bowsprit and bow rollers with anchor clamp swivel.
- Steps from port cockpit seat aft of helm position stainless rods with hand rails to flying bridge or upper deck.
- Safety rails using 1 level solid stainless around the upper deck sides.
ANCHORING
SAFETY EQUIPMENT:
- Emergency Tiller.
- 3 Fire extinguishers.
- Man overboard light.
- Horse shoe life ring and holder.
- Flare pack
ADDITIONAL TRU32 INFORMATION:
Caveat: Specifications and pricing can change at any time. Pricing only fixed at time of signing contract and first payment made.
OPTIONS:
- Flat screen 26" TV on bracket
- Electric Winch, Harken 46
- Water Maker 50 Liter per hour
- 6 man inflatable life-raft in cradle
- Side sheets w/clears & front sheets w/clears
- Gas BBQ on swing arm
- Passerelle on rail & boxed
- Garmin Radar
- Garmin touch screen Chart Plotter
- Solar Panels, 230 Watt
- 2 additional house batteries - 210 Amp
- 2000W Inverter instead of standard 1600
- Air Conditioner
- Deck wash or Hot & Cold Deck Showers
Or other items such as: additional seating facilities, dinghy davits, larger tanks, water makers, fishing equipment, BIGGER engines, etc.
TRU Yachts, provide the Lifestyle, you just choose your optional feel-good bits!
DisclaimerThe Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
Email
Facebook
On LinkedIn
To Pinterest
Your Followers